Specialty Products

Corrugated Shield Special

The Pacific Shoring Corrugated Shield is a lightweight aluminum shoring shield that is intended for use in utility installation and repair applications. These shields are available in hydraulic and static modes. 

They are constructed from corrugated aluminum sheets, heavy-duty waler rails, and 2” aluminum hydraulic cylinder struts with a spring-loaded contraction system. 

Shields are available in:

• 6 ft, 8 ft, and 10 ft heights  
• 6 ft, 8 ft, 10 ft, and 12 ft lengths  
• 3 ft to 10 ft allowable trench widths  
• 2 ft to 5 ft pipe clearance (depending on soil type)

Tabulated Data

H-Frame System

The Pacific Shoring H-Frame with Heavy-Duty Waler Rail is a support solution for pipe or duct. It is a hydraulic jack frame that is used in conjunction with steel sheeting such as sheet plates and steel plates. 

The shoring system can be utilized to achieve wide trenches with large trench bottom to strut clearances. Shore Spacing is also increased over typical trench jack and A-Frame shoring systems. The H-Frame Shore can be used vertically or horizontally with sheeting attached or set prior to setting the frame.

Tabulated Data

S Panel

The Pacific Shoring Aluminum S Panel Shields are lightweight smooth wall shoring shields. They are easily handled with a backhoe or light excavator. These shields are constructed in 8 ft, 6 ft, 4 ft, and 2 ft configurations. The 8 ft shield allows 4 to 5 ft clearance when the box is set at the bottom of the trench and up to 7 ft clearance when the shield is set 2 ft off the bottom. S Panel shields can be used with pinned struts to an allowable trench width of 12 ft, and hydraulic struts to an allowable trench width of 12 ft. S Panel shields can be end loaded with sheeting to a width of 10 ft. This shoring system is generally used in light utility work, water systems, gas and electrical duct bank installations. The optimum range of depth is 8 ft to 12 ft.

Tabulated Data

Single-Piece Extension

The Pacific Shoring Products Single-Piece Extensions are used to extend the overall range of a 2-inch hydraulic cylinder. This extension is designed to provide quick and efficient installation on both solid and hollow rod applications. What sets this extension apart from traditional full-length oversleeve extensions is that you can use them on any of the six standard cylinder sizes. The single welded extension unit can be conveniently added or exchanged onto hydraulic cylinders in the field. Single-Piece Extensions are available in lengths from 6 Inches to 56 Inches and can be ordered with custom intermediate spacing if necessary.

Tabulated Data